kind of self-explanatory, right? We seem to have some impressive thread-wrappers that lurk around this board. let's try to keep your "first booger" posts at a minimum.
User avatar
By ScottP
#580360
Image

Mick Hall's bullethead variation on the Turck Tarantula was the Jackson Hole One Fly winner in '96. Cool fly, mostly petrochemical byproducts.

hook - Dai Riki 280 #8
thread - UTC 140 yellow
undertail - Congo Hair white
overtail - Krystal Flash pearl
body - 2mm foam yellow
underwing - Congo Hair white
overwing - Krystal Flash pearl
head - elk hair
legs - medium rubber yellow


Mash down barb; start thread at eye, cover gap width

Image


clean, stack, measure (hook length) a thick clump of elk hair; tie in (2 soft loops), apply steady tension, let it spin

Image

Image

Image


trim butts, cover shank with thread

Image


tie in a clump of CH; wrap back to bend and trim (gap width)

Image

Image


tie in some KF, fold and wrap back to bend; trim a little longer than the CH

Image

Image


tie in a strip of 2mm foam (about 1/3 gap width); squirt a little Super Glue on the shank, wrap it forward, tie off and trim

Image

Image

Image


tie in another (thicker) clump of CH; trim about even with the overtail

Image

Image


tie in overwing, trim even with underwing

Image

Image


push the elk hair back, make sure it's evenly distributed around the hook eye

Image


pull the hair back, capture it with 2 soft wraps then pull it tight

Image

Image

Image


add legs

Image


whip finish, SHHAN and you're done (you could trim out the hair under the throat - I left it as in the original tie)

Image

Image

Image
Thumbing Through Some SBSs

Microwave Dyeing II Reposting this with some[…]

Winter steelhead fly swap 2019

mine went to post last Thurs. sounds like G is ha[…]

A Drakian's dog, no doubt. But I'd do it again.j[…]

Hope everyone is looking forward to IG Horowitz re[…]

Subsribe to The Drake Magazine